ShotPulled › Gear › DF64 Gen 2
MiiCoffee / Turin / DF64 Gen 2 cleaning and settings: what the manual says
DF64’s manual lists 7 maintenance jobs for the Gen 2. Each is below with how often and the sentence it comes from.
What to do, and how often
| Job | How often | The manual’s sentence |
|---|---|---|
| Bearing / thread lubrication | When the grind dial is stiff or stuck |
|
| Burr clean | No interval given |
|
| Burr replacement | When edges are dulled or chipped; no kg figure |
|
| Cleaning tablets | When oil builds up on the burrs |
|
| Quick clean | No interval given |
|
| Exit chute brush-out | No interval given |
|
| Declumper clean / replace | Periodically; wear item |
|
The collar
- Adjustment
- Stepless
- Finer is
- Not recorded for this model
- How a setting reads
- A number on the dial, in steps of 0.5; lower is finer
- What one step is worth
- The maker publishes no figure
Step-by-step guides
What the manual does not say
3 jobs with nothing stated
- Seal / gasket replacement
- Grounds cup / catch clean
- Hopper clean
Notes from the research
- The maker gives a cleaning procedure but no interval for any task; intervals and tablet/grease/burr-wear guidance are community (retailer) only.
- No burr life in kg; burrs are excluded from the warranty.
- Nothing on hopper, dosing cup or seal care.
Sources
- DF64 coffee grinder instructions (EN) Manual
- Turin Grinders blog (by Espresso Outlet): Troubleshooting Guide for the Turin DF54, DF64 Gen 2 and DF83 Gen 2 (Aug 2025) Maker’s support page
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.
Community: the maker’s text, hosted somewhere else, usually by a retailer.