ShotPulled › Gear › Burr clean
Clean the burrs and outlet: DF64 Gen 2
Before you start
- Tools
- dry brush, blowing hopper (supplied)
- Supplies
- None listed
Warnings
- Do not wash the grinder, inside or out, with water. Source: DF64 coffee grinder instructions (EN)
- Disconnect the power before removing or refitting parts. Source: DF64 coffee grinder instructions (EN)
- Take care handling the burrs while they are out. Source: DF64 coffee grinder instructions (EN)
Steps
- With the grinder running, fit the blowing hopper on the upper burr holder and press it to blow out leftover grounds.
From the manual: “pr esst hebl owi nghoppert obl ow outt her esi dualpowderi nsi det hegr i nder”
- Switch off and pull out the power plug before going further.
From the manual: “2.Pul loutt hepowerpl ug”
- Turn the adjusting disc anticlockwise until it comes off.
From the manual: “Tur nt headj ust i ngdi sc ant i cl ockwi set ot akei tout”
- Lift out the upper burr holder.
From the manual: “andt hent akeoutt heupperbur r hol der”
- Brush the upper and lower burrs clean with a dry brush.
From the manual: “3.Cl eant heupanddownbur rwi t hadr ybr ush;”
- Brush out the outlet with a dry brush.
From the manual: “4.Cl eant heout l etwi t hadr ybr ush;”
- Refit the upper burr holder and screw the adjusting disc back on, pressing the holder down.
From the manual: “5.Rei nst al lt heupperbur rhol derandputt headj ust i ngdi sc on,pr esst heupperbur rhol der”
- Turn the adjusting disc clockwise until it stops.
From the manual: “r ot at et headj ust i ngdi sc cl ockwi seunt i li tcan' tmove”
- Back the disc off anticlockwise to 10 on the scale, then set your usual grind.
From the manual: “t henadj usti tcount er cl ockwi se t oscal e1 0.”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.