ShotPulled › Gear › Burr clean
Brush the burrs clean: Weber Workshops HG-2
Before you start
- Tools
- integrated cleaning brush, air blower (optional)
- Supplies
- None listed
Warnings
- The burrs are extremely sharp; keep fingers clear. Source: HG-2 grinder quick start guide (2024 v9.1)
- Burr alignment is set at the factory and cleaning does not disturb it; do not adjust it. Source: Weber Workshops: The HG-2 Mk.2 product page
Steps
- Lift the dust lid off, or raise it on its magnets, to expose the bean feeder opening above the burrs.
From the manual: “The dust lid can be removed or suspended above with magnets”
- Brush and blow air over the top to dislodge powder sitting above the burrs.
From the manual: “A few brush strokes and blasts of air on top can dislodge any powder above the burrs.”
- Twist the lower funnel off its magnets.
From the manual: “can be removed with a simple twist of the wrist.”
- Brush the exposed lower burrs clean.
From the manual: “Once exposed, the lower burrs can be brushed clean in seconds.”
- Brush the burr, funnel and basemat.
From the manual: “use brush to clean the burr, funnel, basemat, etc.”
- Slide the brass sleeve over the bristles before putting the brush back in the handle.
From the manual: “first pull brass outer sleeve to cover bristles before re-insertion.”
Sources
- HG-2 grinder quick start guide (2024 v9.1) Manual
- Weber Workshops: The HG-2 Mk.2 product page Maker’s page
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.