ShotPulled › Gear › Steam wand deep clean
Run the ST CLEAN steam-circuit program: WPM KD-310
Before you start
- Time
- About 10 minutes
- Tools
- None listed
- Supplies
- None listed
Warnings
- At 400 steam-wand uses the machine will not work until the steam wand has been cleaned. Source: WPM Welhome KD-310 EU series instruction manual (EN/ZH)
- The steam wand gets very hot; avoid touching it. Source: WPM Welhome KD-310 EU series instruction manual (EN/ZH)
The machine tells you when
This machine keeps count itself and tells you when this job is due, so follow the machine rather than a calendar.
- What you see
- 'ST CLEAN' on the display
- Shown as
- A message on the display
- What it counts
- Uses
- How it clears
- running the ST CLEAN program; at 400 steam-wand uses the machine locks until it has been run
Source: WPM Welhome KD-310 EU series instruction manual (EN/ZH)
Steps
- Make sure the water tank has water in it before starting.
From the manual: “Please make sure there is water in the water tank during the cleaning procedures.”
- In standby, press CLEAN twice so the display reads ST CLEAN.
From the manual: “Press the button TWICE, “ST CLEAN” will appear on the LCD screen.”
- Press PROGRAM within 5 seconds to start, or the machine drops back to standby.
From the manual: “to clean the water circuit of the steam wand.”
- Open the steam wand; the program runs for about 10 minutes.
From the manual: “Turn the steam wand on, this procedure will last for around 10 minutes.”
- When CHECK appears, close the steam wand.
From the manual: ““CHECK” will be shown on the LCD screen to remind users to turn the steam wand off.”
- If NO WATER appears, refill the tank and press SETTING/P to carry on. Optional
From the manual: “press the SETTING/P button to continue cleaning after refilling the tank.”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.