ShotPulled › Gear › (free label)
Run the CO CLEAN group-circuit program: WPM KD-310
Before you start
- Time
- About 7 minutes
- Tools
- None listed
- Supplies
- None listed
The machine tells you when
This machine keeps count itself and tells you when this job is due, so follow the machine rather than a calendar.
- What you see
- 'CO CLEAN' on the display
- Shown as
- A message on the display
- What it counts
- Litres of water
- Depends on
- cleaning-reminder water limit in the settings menu: 50, 100 or 180 L
Source: WPM Welhome KD-310 EU series instruction manual (EN/ZH)
Steps
- Once: in standby open the settings, step to the cleaning limit, pick 50, 100 or 180 L with minus/plus, and save. Optional Only when: setup
From the manual: “set the water usage limit for cleaning reminder (range: 50L / 100L / 180L)”
- Make sure the water tank has water in it before starting.
From the manual: “Please make sure there is water in the water tank during the cleaning procedures.”
- In standby, press CLEAN once so the display reads CO CLEAN.
From the manual: ““CO CLEAN” will appear on the LCD screen.”
- Press PROGRAM within 5 seconds to start, or the machine drops back to standby.
From the manual: “to clean the water circuit of the group head.”
- Let it run: three buttons light one after another, for about 7 minutes.
From the manual: “this procedure will last for around 7 minutes.”
- If NO WATER appears, refill the tank and press SETTING/P to carry on. Optional
From the manual: “press the SETTING/P button to continue cleaning after refilling the tank.”
- To stop early, hold CLEAN for 3 seconds to return to standby. Optional
From the manual: “press and hold “CLEAN” button for 3 seconds to stop and back to standby mode.”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.