ShotPulled › Gear › Built-in grinder burr clean
Brush the grinder burrs: Sage Oracle Touch
Before you start
- Tools
- burr brush (supplied), grind outlet brush (supplied), tamp removal magnet (supplied)
- Supplies
- None listed
Warnings
- If the burrs got wet, let them dry fully before reassembly. Source: Sage the Oracle Touch SES990 instruction book (UK, EN)
Steps
- Unlock the bean hopper and empty the beans out of it.
From the manual: “Unlock hopper Remove beans”
- Refit and lock the empty hopper.
From the manual: “Replace & lock hopper”
- Run the grinder until no coffee comes out.
From the manual: “Run grinder until empty”
- Unlock the hopper and lift it off.
From the manual: “Unlock & remove hopper”
- Take out the upper burr.
From the manual: “Remove upper burr”
- Brush the upper burr with the burr brush.
From the manual: “Clean upper burr with burr brush”
- Brush the lower burr in the machine with the burr brush.
From the manual: “Clean lower burr with burr brush”
- Lift out the tamping fan with the tamp removal magnet.
From the manual: “Remove tamping”
- Brush the grind outlet with the grind outlet brush.
From the manual: “Clean grind”
- Put the tamping fan back by hand.
From the manual: “Replace tamping fan with tamp outlet with grind fan by hand”
- Push the upper burr firmly into place and lock it.
From the manual: “Push upper burr firmly into position Lock upper burr”
- Refit the hopper and lock it.
From the manual: “Insert hopper”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.