ShotPulled › Gear › Burr clean
Brush the burrs: Sage Dose Control Pro
Before you start
- Tools
- cleaning brush (supplied), container for the beans
- Supplies
- None listed
Warnings
- No alkaline or abrasive cleaners or scouring pads. Source: Sage the Dose Control Pro SCG600 instruction book (Nordic/EU, EN section)
Steps
- Unlock the bean hopper.
From the manual: “Unlock hopper Hold hopper over container”
- Hold the hopper over a container and turn its dial to let the beans run out.
From the manual: “Hold hopper over container & turn dial to release beans into container”
- Set the hopper back in position.
From the manual: “Align hopper into position”
- Run the grinder until nothing more comes out.
From the manual: “Run grinder until empty”
- Unplug the grinder before cleaning.
From the manual: “Unplug power cord from power outlet before cleaning.”
- Take the hopper off, then lift out the upper burr.
From the manual: “Remove hopper Remove upper burr”
- Brush the upper burr clean.
From the manual: “Clean upper burr with a brush”
- Brush the lower burr in the grinder.
From the manual: “Clean lower burr”
- Brush out the grind outlet with the cleaning brush.
From the manual: “Clean grind outlet with cleaning brush”
- Push the upper burr firmly back into place and lock it.
From the manual: “Lock upper burr firmly into position”
- Set the hopper in position and lock it.
From the manual: “Align hopper into position Lock hopper”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.