Clear a blocked grinder (advanced clean): Sage Barista Touch Impress

Before you start

Tools

10 mm socket, long-nose pliers, cleaning brush (supplied) or a pipe cleaner

Supplies

None listed

Warnings

• The burrs are very sharp; handle them carefully. Source: Sage the Barista Touch Impress BES881/SES881 user guide (EU Nordic, multilingual; EN section)

Steps

1. Only do this if grounds are blocked between the burrs and the outlet. Start by removing the hopper.

   From the manual: “This step is only required if there is a blockage between the grinding burrs and the grinder outlet.”

2. Set GRIND SIZE to 1, the finest setting.

   From the manual: “Set GRIND SIZE to 1 (finest)”

3. With a 10 mm socket, turn the burr nut clockwise just to loosen it; do not remove it yet.

   From the manual: “Use 10mm socket. Rotate clockwise to loosen the nut only”

4. Set GRIND SIZE to 25, the coarsest setting.

   From the manual: “Set GRIND SIZE to 25 (coarsest)”

5. Unlock the top burr and take it out.

   From the manual: “Unlock & remove top burr”

6. Take off the nut, spring washer and flat washer, then carefully lift out the lower burr.

   From the manual: “Carefully remove lower”

7. Pull out the grind fan and its washers with long-nose pliers.

   From the manual: “Remove grind fan”

8. Clear the grinds exit chute with the brush or a pipe cleaner.

   From the manual: “Unblock the grinds exit chute using the brush or a pipe cleaner”

9. Take off the tamp cover and brush the chute clean.

   From the manual: “Remove tamp cover 15 16 Clean the chute with brush”

10. Refit with the pliers in this order: felt washer, metal washer, grind fan.

    From the manual: “Insert washers & grind fan using long-nose pliers”

11. Refit the lower burr with its drive pin in the cavity, then the flat and spring washers.

    From the manual: “Insert lower burr (drive pin & cavity to align). Insert flat washer & spring washer.”

12. Tighten the nut by turning it anticlockwise.

    From the manual: “Rotate counter-clockwise to tighten nut”

13. Refit the top burr and lock it.

    From the manual: “Insert & lock top burr”

14. Set GRIND SIZE to 16 and put the tamp cover back.

    From the manual: “Set GRIND SIZE to 16 Replace tamp cover”

15. Refit the hopper and lock it.

    From the manual: “Replace hopper Lock hopper”

Sources

• Sage the Barista Touch Impress BES881/SES881 user guide (EU Nordic, multilingual; EN section) Manual

Researched on 2026-09-23.

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to

• Sage Barista Touch Impress