Clean the burr chamber: Option-O Lagom P64

Before you start

Tools

hex wrench, brush, vacuum (optional), slightly moist cloth

Supplies

None listed

Warnings

• Never vacuum from above the funnel without taking it apart: the suction can bend the de-clumping screen. Source: LAGOM P64 Safety Manual (September 2023)
• Leave the centre bolt on the bottom burr carrier alone unless a repair needs it. Source: OPTION-O: LAGOM P64 User Guide & Resources
• Do not overdo the torque on the hex screws; it can damage the hex tool. Source: OPTION-O: LAGOM P64 User Guide & Resources
• Nothing goes in the dishwasher. Source: LAGOM P64 Safety Manual (September 2023)
• Never immerse the grinder or its parts in water or any liquid. Source: LAGOM P64 Safety Manual (September 2023)

Steps

1. Switch the grinder off and remove the power cord.

   From the manual: “Remove the power cord when cleaning the grinder.”

2. Lift off the magnetic outer ring.

   From the manual: “Lift the magnetically-attached outer ring.”

3. Loosen the two side hex screws by 1-2 turns without taking them out.

   From the manual: “Loosen the two hex screws on the side by 1-2 rotations”

4. Press the collar down and twist it counter-clockwise to release it.

   From the manual: “apply downward pressure and twist the collar counter-clockwise.”

5. Lift out the upper burr carrier to reach the burr chamber.

   From the manual: “Lift the upper burr carrier to access the burrs chamber.”

6. Clean the chamber with a brush, a vacuum, or both.

   From the manual: “To clean the grind chamber, we recommend using a brush and/or a vacuum cleaner.”

7. Give the bean hopper a quick wipe with a slightly moist cloth.

   From the manual: “To clean the bean hopper, we recommend a quick wipe with a slightly moist cloth.”

8. Refit the upper assembly and bring both hex screws to finger-tight, pressing down on the funnel if it helps.

   From the manual: “Begin by tightening both screws on both sides with hex wrench until they are finger-tight.”

9. Then tighten one screw at a time, a little more force each time, until it no longer turns.

   From the manual: “On one of the screws, gradually apply a little more force at a time with the hex wrench.”

10. Do the same with the other screw.

    From the manual: “Repeat the same process for the other screw on the other side.”

Sources

• OPTION-O: LAGOM P64 User Guide & Resources Maker’s support page
• LAGOM P64 Safety Manual (September 2023) Manual

Researched on 2026-09-23.

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to

• Option-O Lagom P64