ShotPulled
Gear Home

ShotPulled › Gear › Burr clean

Clean the burr chamber: Option-O Lagom P100

Before you start

Tools
brush, vacuum or shop vac (optional), lightly moist cloth
Supplies
None listed

Warnings

Steps

  1. Unplug the grinder before you start.

    From the manual: “To clean the grinder, we recommend unplugging the grinder first.”

  2. Unscrew the lock ring by hand, turning it counter-clockwise as seen from above.

    From the manual: “undo the lock ring (part 3) by hand.”

  3. Carefully lift the upper burr carrier straight up to expose the burrs.

    From the manual: “carefully lift up the upper burr carrier and the burrs will be accessible for cleaning.”

  4. Loosen and remove the grounds with a brush or a vacuum such as a shop vac.

    From the manual: “Use a brush or vacuum (e.g. shop vac) to loosen and remove the grind.”

  5. Wipe the inside of the bean hopper with a lightly moist cloth.

    From the manual: “Use a lightly moist cloth to wipe the inside of the bean hopper.”

  6. Before reassembling, check every mating surface is free of coffee debris.

    From the manual: “make sure all mating/contact surfaces are free of coffee debris.”

  7. Refit the upper carrier and lock ring; tighten the ring only lightly so it does not stick.

    From the manual: “does not have to be tightened too much to avoid it getting stuck.”

  8. If auto-grind now stops early or late, recalibrate: with the grinder empty, hold the auto-grind switch about 10 s until the motor runs, then let the cycle finish. Optional Only when: if the auto-purge misfires after cleaning

    From the manual: “start with an empty grinder, press and hold the auto-grind switch for approx. 10s until the motor is engaged.”

Sources

Researched on .

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to