Remove the shower screen and replace the gasket: Ninja Luxe Café ES601

Before you start

Tools

Phillips-head screwdriver, flathead screwdriver

Supplies

replacement group head gasket (Ninja part, sold at sharkninja.com), optional

Steps

1. Switch the machine off and unplug it.

   From the manual: “Be sure that the machine is turned off and unplugged before proceeding.”

2. Undo the central screw of the shower screen with a Phillips screwdriver and take the screen off.

   From the manual: “Using a Phillips-head screwdriver, remove central screw on shower screen, then remove shower screen.”

3. Wash the shower screen with soap and water.

   From the manual: “clean the shower screen with soap and water.”

4. Prise the rubber gasket out of the group head with a flathead screwdriver.

   From the manual: “Remove rubber gasket from group head with flathead screwdriver.”

5. Check the gasket for wear or tears and fit a new one if needed.

   From the manual: “Inspect gasket for any wear or tearing, and replace with a new gasket if needed”

6. Put the shower screen back and fasten it with its screw.

   From the manual: “Insert shower screen back into group head and secure in position with screw.”

Sources

• Ninja Luxe Café ES600 Series owner's guide (ES601_IB_master; covers ES601, ES601BK, ES601BL, ES601GM, ES601C), attached to support.sharkninja.com/article/ES600-Series-Ninja-Luxe-CafC3A9-Owner-s-Guide Manual

Researched on 2026-09-23.

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to

• Ninja Luxe Café ES601