ShotPulled
Gear Home

ShotPulled › Gear › Automatic milk system clean

Wash the milk reservoir and flush the froth tube: Mr. Coffee Cafe One-Touch

Before you start

Tools
large empty cup
Supplies
mild dish soap (in warm water)

Warnings

Steps

  1. Lift the milk reservoir release button and slide the reservoir off the unit.

    From the manual: “Remove the milk reservoir from the unit by lifting up the milk reservoir release button”

  2. Take the lid off the reservoir.

    From the manual: “Remove the lid of the reservoir.”

  3. Pour out any milk, then wash reservoir and lid in warm soapy water, rinse and dry well (the reservoir alone may go on the dishwasher top rack).

    From the manual: “Dispose of any milk left, then rinse and wash the milk reservoir and its lid thoroughly with warm soapy water.”

  4. Fill the reservoir with water, no higher than MAX, and slide it back on holding it by the lid.

    From the manual: “Fill milk reservoir with water, not above the MAX fill line.”

  5. Put a large empty cup under the froth dispensing tube.

    From the manual: “Place a large empty cup under the froth dispensing tube.”

  6. Turn the Froth Control Knob anticlockwise to clean and press Clean; steam starts through the tube.

    From the manual: “The unit will start releasing steam through the froth dispensing tube.”

  7. Let it run until no milk comes out, or until it stops by itself.

    From the manual: “or let the cycle run until it stops automatically”

  8. Pour out the water left in the reservoir and refit it until it locks.

    From the manual: “Dispose of any water left in the milk reservoir and place it back in the unit.”

Sources

Researched on .

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to