ShotPulled
Gear Home

ShotPulled › Gear › Automatic milk system clean

Clean the frothed-milk tube and milk reservoir: Mr. Coffee Cafe Barista

Before you start

Time
About 0.5 minutes (the clean function itself runs 30 seconds)
Tools
large empty cup
Supplies
mild dish soap (in warm water, for a full reservoir clean), optional

Warnings

Steps

  1. Put a large empty cup under the frothing tube and check the water reservoir has water in it.

    From the manual: “Place a large empty cup under the frothing tube and make sure there is water in the water reservoir.”

  2. Point the Frothed Milk Dispensing Tube into the cup.

    From the manual: “Aim the Frothed Milk Dispensing Tube into the empty cup.”

  3. Set the Froth Control Knob to Clean.

    From the manual: “Adjust the Froth Control Knob to Clean”

  4. Hold Latte/Clean until the pump starts, then let go; it runs 30 seconds and stops (press again to stop early).

    From the manual: “until pump starts, then release it. The clean function will run for 30 seconds and then stop automatically.”

  5. Pour away what collected in the cup.

    From the manual: “Once completed, throw the contents in the cup away.”

  6. If keeping the milk, put the milk reservoir with its milk in the fridge. Only when: keeping the leftover milk

    From the manual: “the milk reservoir with milk can now be stored in the refrigerator.”

  7. Otherwise take the milk reservoir off and pour out the remaining milk. Only when: full clean

    From the manual: “Remove milk reservoir from appliance and discard any remaining milk.”

  8. Wash every part of the reservoir and its lid in warm soapy water, rinse and dry well (top-rack dishwasher safe). Only when: full clean

    From the manual: “Rinse and wash all parts of the milk reservoir container and lid thoroughly with warm soapy water.”

Sources

Researched on .

Published: the sentence is on the maker’s own page or in the maker’s own document.

Applies to