ShotPulled › Gear › Burr clean
Dismantle and brush the burrs: Kingrinder K2
Before you start
- Tools
- brush (supplied)
- Supplies
- None listed
Warnings
- Never wash any part of the grinder with water; clean it with the brush. Source: KINGrinder K0/K1/K2 manual (EN), linked from kingrinder.com/manual
- Leave the outer burr in place and never force the grinder apart with tools. Source: KINGrinder K0/K1/K2 manual (EN), linked from kingrinder.com/manual
- Do not turn the handle with the setting at 0 or under 16 clicks; it can damage the burrs. Source: KINGrinder K0/K1/K2 manual (EN), linked from kingrinder.com/manual
- Do not spray water directly on any part; for RDT, spray the beans in a separate container. Source: KINGrinder K0/K1/K2 manual (EN), linked from kingrinder.com/manual
Steps
- Take off the powder receiver.
From the manual: “HOW TO CLEAN THE GRINDER? 1.Remove the Powder receiver.”
- Grip the body and the handle together in one palm so the handle cannot turn.
From the manual: “Hold the grinder body and the handle firmly together with the palm of one hand”
- Turn the spin dial counterclockwise to open the grinder.
From the manual: “Rotate the spin dial counterlockwise to disassemble the grinder.”
- Lift out, in this order, the spin dial, numerical dial, inner burr, spring and bearing cover; leave the central shaft in.
From the manual: “Take out the components in order: spin dial, numerical dial, inner burr, spring, and bearing cover.”
- Brush the grinder and the parts clean.
From the manual: “Use the brush to clean the grinder.”
- Refit the bearing cover, curved side up, then the spring.
From the manual: “Ensure the curved design faces upward.”
- Seat the inner burr and the numerical dial on the rectangular section of the central shaft.
From the manual: “Attach the inner burr and the numerical dial to the rectangle shape of the central shaft”
- Screw the spin dial on clockwise to finish the assembly.
From the manual: “Install the spin dial and rotate clockwise to complete the assembly.”
- Re-zero: holding body and handle, turn the adjustment nut clockwise just until you feel resistance, without forcing it.
From the manual: “Turn the adjustment nut clockwise until you feel resistance”
- Note the number at the triangle marker; that is your zero reference.
From the manual: “Note the number (or position) indicated by the triangle marker after zeroing.”
- Turn the adjustment nut counterclockwise back to your grind setting and refit the powder receiver.
From the manual: “Turn the adjustment nut counterclockwise to the recommended grind setting”
Sources
Researched on .
Published: the sentence is on the maker’s own page or in the maker’s own document.